904-090
November 14, 2003

Remember, 090 had the roll bar down bars that were cut loose from the bottom of the tower, bent upward and re-welded at the top of the tower (not so good). We cut the bars out and replaced them with a straight bar. Plus, we welded a backing plate on the tower before welding the roll bar, which gives more integrity to the strength of the rear of the chassis.

Mark is cutting the bent bar out.

Pretty ugly, eh!

The old bar is now removed and metal finished. The new bar is ready for welding.

This is the base plate and the new bar that we welded on top of the base plate. If you look close in the picture on the right, the bar on the left is new and the bent bar remains on the right side.

The left bar is tacked and ready for welding.

<<< Previous Update | Next Update >>>